PDA

View Full Version : NBv3 Problem



chrisharrisonakk@yahoo.co
02-15-2016, 03:00 PM
I am building a lightsaber with a NBv3 board. I made sure all of the wires were connected to the right pads. But when I attach the battery, it seems to bypass the switch and speaker. The led comes on, but I get no sound from the speaker and have no control from the switch. Any ideas on what I should do?

ColdVizjerei
02-15-2016, 03:15 PM
Sounds like you might've goofed on the wiring. We can better help you if you added pictures of your wiring and perhaps a wiring diagram that you used.

Doing so will make it easier for us to pinpoint your problem :)

chrisharrisonakk@yahoo.co
02-15-2016, 03:27 PM
On an unfortunate note, I just tested the board without the led attached, and all I get out of the speaker is a clicking noise

Noyl Wendor
02-15-2016, 08:03 PM
Howdy. :D Make sure you didn't solder your board with the SD card in. That's tops on the list. Make sure your battery is fully charged. Pull your SD card and format it, reload the sound fonts and give it a go. But the best possible way to get help is drop some pictures of the work here in the forums ;) After you've done that maybe there's a simple solution to your problem we can find.