Homemade Bladeholder?

[Nicholas F.]

I wanted to ask if you have any ideas how to build my own blade holder that fits into a 1 1/4" sink tube? i know there is a TCSS blade holder for sink tubes, but unfortunatly there a very high shipping costs from the US to germany and honestly that would be too much for ohne single part :/ do you have alternatives for me? :)
thanks :)

[Greenie]

I used a piece from the end of a mixer tap and a stack of coins for a heatsink. 13027. It may not be the right size for your needs, hey, it might not even be a 'good' idea but it worked for my custom build. 13028.
13029. 13030.

Not sure if this helps but it is an 'idea'. :mrgreen:



Edit: sorry this is an untidy post :(

[djblingbling1]

I asked the same thing a few days ago and heres what I came up with. 1" PVC which means the inner diameter is 1", and then sanded it down so the OD was 1 1/4. I plan on threading it and using 8/32 screws through my sink tube and into the pvc.