cwbrownie
11-04-2015, 08:10 PM
Hi so I'm trying to figure out how to wire a tri-cree with resistors for each die.
I'm planning on using FoC, NB, 3.7V 18650 Li-ion batt, and b/b/w led.
I was looking at Madcow's tut on wiring in parallel and only using 1 resistor, but
people have recommended using a resistor for each die so I'm wondering how thats done?
I'm planning on using FoC, NB, 3.7V 18650 Li-ion batt, and b/b/w led.
I was looking at Madcow's tut on wiring in parallel and only using 1 resistor, but
people have recommended using a resistor for each die so I'm wondering how thats done?