Blade
10-19-2015, 08:14 AM
I've been planning this saber for years. Had to back out of it for awhile but now I'm picking it back up with a complete redesign.
These are the parts I need:
7.4v Li-ion 800mAh 14500 Battery Pack
1.2" Double Female
Double Male Extension
Hilt style 3
MHS Sleeve material
9" Electronics shield for 1.25" ID tubes
Covertec Clip
16mm Anti Vandal Short Momentary White Ring Switch
16mm Anti Vandal Short Momentary Blue Ring Switch
20mA DynaOhm? Variable Resistor
26 gauge wire (25' Spool)
.75" Male / Female extension
MHSV1 Blade Holder Style 9
MHSV1 Blade Holder Style 25 (Ordered)
Star thermal tape pad
MHS Heat Sink V3
3.5mm R.I.C.E.? Port Style 1
2W 28mm Bass Speaker
Crystal Focus v7.5
CEx Board v3
Power Xtender? 2.0
All-in-1 Crystal Focus chassis - 1.24" OD
These are the parts I have:
2 inch Crystal Chamber
Cree MCE - RGBW High Power LED w/ lens
Screw Sets
These are the parts I need:
7.4v Li-ion 800mAh 14500 Battery Pack
1.2" Double Female
Double Male Extension
Hilt style 3
MHS Sleeve material
9" Electronics shield for 1.25" ID tubes
Covertec Clip
16mm Anti Vandal Short Momentary White Ring Switch
16mm Anti Vandal Short Momentary Blue Ring Switch
20mA DynaOhm? Variable Resistor
26 gauge wire (25' Spool)
.75" Male / Female extension
MHSV1 Blade Holder Style 9
MHSV1 Blade Holder Style 25 (Ordered)
Star thermal tape pad
MHS Heat Sink V3
3.5mm R.I.C.E.? Port Style 1
2W 28mm Bass Speaker
Crystal Focus v7.5
CEx Board v3
Power Xtender? 2.0
All-in-1 Crystal Focus chassis - 1.24" OD
These are the parts I have:
2 inch Crystal Chamber
Cree MCE - RGBW High Power LED w/ lens
Screw Sets