Dcoil03
10-16-2015, 11:17 PM
I downloaded a custom sound font that consisted of .lsu files which I then converted to 16bit WAV, 22050 sample rate with Audacity. The biggest file size is 258kb, for a grand total of 1.01MB for the entire font file.
I replaced the darkmeat sound font in the "bank1" folder with the custom sounds, didn't change the names, didn't change the config files, just copied and pasted the new sound fonts into the folder with the same filenames.
Now, when I activate my saber, the boot sound will play, followed by a few random clash and swing sounds immediately following it. If I leave the saber alone, the hum will play but then the poweroff sound (about 3/4 of the sound)and a clash will play, and this will cycle continuously every 5 seconds until the power the saber down myself (Hum/poweroff/clash/hum/poweroff/...etc.)
Anyone have any ideas what's causing this? I really like this sound font and I'd hate to have to scrap it.
I replaced the darkmeat sound font in the "bank1" folder with the custom sounds, didn't change the names, didn't change the config files, just copied and pasted the new sound fonts into the folder with the same filenames.
Now, when I activate my saber, the boot sound will play, followed by a few random clash and swing sounds immediately following it. If I leave the saber alone, the hum will play but then the poweroff sound (about 3/4 of the sound)and a clash will play, and this will cycle continuously every 5 seconds until the power the saber down myself (Hum/poweroff/clash/hum/poweroff/...etc.)
Anyone have any ideas what's causing this? I really like this sound font and I'd hate to have to scrap it.