3d file aka STL of covertec clip

[Jordandau]

Hey guys, I'm going to start putting together a starkiller costume and while I have 1 covertec clip that I purchased right here... The costume requires a few more. I have access to a 3d printer so I was thinking if I could find a 3d file I could just print off some replicas. Does anyone happen to know of such a file? I just spent 2 hours on all the obvious choices, thingaverse, shapeways etc. Just wondering if anyone knew outright of one. If not, I'll just start my own.

[Thalan the Exiled]

Haven't seen one but could make one if you need. Just have to wkrk out the specs for it. Flat bottom or curved to match hilt?

[Miraluka]

Haven't seen one but could make one if you need. Just have to wkrk out the specs for it. Flat bottom or curved to match hilt?

Clip, not knob.

[Thalan the Exiled]

The clip will be a bit harder to print. It has moving parts that when printed wouldn't be functional

[Miraluka]

Agreed. Seems like more hassle than it's worth since they're pretty inexpensive already.

[Jordandau]

I couldn't find one at all. So I just made it. I made it in 4 pieces (5 if you count the wings twice). I don't need them functional so these should work good if anyone else like me is doing a starkiller costume, where you just need like 5 clips on your belt. I'll offer it to anyone here that wants it. But I think I may also put it up on shapeways, since I couldn't find any. You'd just stack and glue it together.

[Jordandau]

Is it ok if I post a shapeways link?