View Full Version : FOC Color Choice?
Darth Nurse
09-20-2015, 09:49 PM
I plan to run parallel red-orange and Amber CREEs to get a nice blade orange.
What color would you use for your FOC LED?
I am thinking another rO.
darth_chasm
09-20-2015, 10:01 PM
Personally I would worry that it wouldn't be noticeable enough. I would do white or even green if it were me.
Count Malik
09-20-2015, 11:17 PM
Green would make it more of a yellowish *as close to film accurate* FOC as possible. White would be very cool as well. It really depends on what you're going for.
Darth Nurse
09-21-2015, 08:57 AM
I think I will go with green then, thank you.
Does the green require a resistor for FOC if wired with the NB and PEX?
Forgetful Jedi Knight
09-21-2015, 09:15 AM
I think I will go with green then, thank you.
Does the green require a resistor for FOC if wired with the NB and PEX?
Yes it does.
Darth Nurse
09-21-2015, 09:57 AM
Yes it does.
Thank you. I will do the math and get it in there.
Darth Nurse
09-21-2015, 11:24 AM
I come up with a 1 ohm 2 watt resistor for the green.
I take it I wire this direct and not worry about the resistor for the PEX?
bigkevin61
09-21-2015, 08:25 PM
I have a red-amber-white with red-amber in parallel for orange (suggested by Yoshi-Taka).
The white is for FOC, and when activated, make a pale/pastel orange blade.
I think "Dreamcicle" for this setup.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.