PDA

View Full Version : What happened to B3flex menu access ???



Aleyan
07-21-2015, 05:36 AM
Hello everyone...

This is my very first post ever on this forum and I would like to quickly greet everyone !!!

That being done, I have a question :

I recently bought the "Constant current LED driver (http://www.thecustomsabershop.com/Constant-current-LED-driver-P609.aspx)" from TCSS which is actually the B3flex driver from Taskled.

In the manual from tasked (http://www.taskled.com/leds/b3flexuni4_v1.00.pdf), there are 3 possible procedures to enter the driver's menu in order to make adjustments in the configuration (which was performed by TCSS). However, none of those methods work.

So my question is : Is the menu blocked by TCSS's programming and how do I access it to make the one modification I need for my saber?!!!

Thank you all for your attention and answers !!!

MTFBWY

Alexandre "Aleyan" Ariosa

Strydur
07-21-2015, 06:07 AM
It is based on the B3flex but with completely different firmware which is why you cannot use it the same way.

Aleyan
07-21-2015, 07:47 AM
Ok, I understand.

Thanks for the answer.

Then, I have a few questions :

- Is it normal for it to turn off with a simple click. Isn't the whole purpose of the momentary switch to avoid unintentional switch offs by having to hold it down 2 seconds ?
- Is it possible to adjust the timing for the off switch function ?
or
- Is there a way to alter the programming so it can be wired in series with a soundboard and turn on and off simply by the power being injected or not in the +/- connectors ?

Thank you for your time !!!

Alexandre Ariosa