sgcdialler
05-20-2015, 07:58 AM
I'm pretty sure this is all right, but the PLI and crystal chamber LED have me a little nervous (especially the red connection, since there isn't really a pad for that on the PC). I was thinking of soldering the blue and green connections at the CeX end of the connection, instead of the PC's FOC pads, just to keep from cluttering the board. Any suggestions?
EDIT: The specs on the 5mm RGB LED are 2.0V, 3.2V, 3.2V, respectively, all at 20mA.
http://i.imgur.com/rAXbRds.jpg
EDIT: The specs on the 5mm RGB LED are 2.0V, 3.2V, 3.2V, respectively, all at 20mA.
http://i.imgur.com/rAXbRds.jpg