Wiring Check: Tri-Cree, Accent LED Switch, NBv2, FoC

[Twigz]

Good morning/afternoon/evening! This is my first wiring diagram (and my first slightly complex electronics set up).

Parts:

Tri-Cree G/G/W: http://www.thecustomsabershop.com/GreenGreenWhite-Cree-XP-E2-CopperNova-P1015.aspx

Momentary AV switch w/ White Ring LED: http://www.thecustomsabershop.com/16mm-Anti-Vandal-Short-Momentary-White-Ring-Switch-P903.aspx

PowerExtender: http://www.thecustomsabershop.com/Power-Xtender-20-P652.aspx

18650 3.7V 2600mA lion Battery, single cell: http://www.thecustomsabershop.com/Li-Ion-18650-37V-2600mAh-PCB-
Protected-Rechargeable-Battery-Module-P672.aspx (http://www.thecustomsabershop.com/Li-Ion-18650-37V-2600mAh-PCB-Protected-Rechargeable-Battery-Module-P672.aspx)

Premium 28mm Speaker


http://i1148.photobucket.com/albums/o564/Twygzz/saberwiringdiagram_zpsgk1tggex.png (http://s1148.photobucket.com/user/Twygzz/media/saberwiringdiagram_zpsgk1tggex.png.html)

I've done research on both the forums and the Nano Biscotte manual in order to draw this out, though I'm still unsure as to whether I have it all down. My goals (other than simple operation) were to have the accent LED (switch LED) off during deep sleep, and to wire the two green dice in parallel with the white die being used for the FoC effect.
Please and thank you!

[Silver Serpent]

You're missing a connection from the battery negative to the Negative (2nd from top) pad on the board.

Also, the switch LED positive goes on the other side of that capacitor. It looks like you're going to the bottom, but according to p.13 of the manual, it goes on the other side. The rest looks fine.

[Twigz]

Thank you so much! I can't believe I missed that negative connection. xD>