Indis
02-28-2015, 10:56 PM
My flash on clash stays on - when ever I bridge the two top pads with any resistor.
No shorts. But looking at the board it looks like there is supposed to be a part soldered between the R AND - PADS, but all I have is the three terminal device.
Does anyone know what part should be there, it goes across the left two terminals of the three terminal device? Or does anyone have the schematic?
I'd rather not send this back, and just use parts laying around.
Thanks,
Scott
No shorts. But looking at the board it looks like there is supposed to be a part soldered between the R AND - PADS, but all I have is the three terminal device.
Does anyone know what part should be there, it goes across the left two terminals of the three terminal device? Or does anyone have the schematic?
I'd rather not send this back, and just use parts laying around.
Thanks,
Scott