PDA

View Full Version : Saberforge soundboard with Makoto LED's ?



Jegan
02-15-2015, 12:40 PM
Hey guys, this is my first post to the forums, I have a question and that question is. Is it possible to make a saberforge soundboard, more specifically, the sabercore crimson to work with LED's from makoto?
Thanks in advance

-Jegan

Ty_Bomber
02-15-2015, 12:47 PM
This forum is better suited to answer questions regarding products sold in this store, so you want to direct your question to Saberforge. That being said, I would assume not, as only makoto's sound cards MR/Hasbro and the CFLS can support string blades, as they have special wiring pads on their cards to support multiple LEDs within a certain amp and voltage range.

On the other hand, some builders such as Hampton's have set up string blades off of the nano biscotti, but these lack the scrolling effect that is so popular on string blades, so I don't really know.

Your best bet is to ask the vendor themselves.

Forgetful Jedi Knight
02-15-2015, 12:52 PM
Hey guys, this is my first post to the forums, I have a question and that question is. Is it possible to make a saberforge soundboard,

-Jegan
That vendor isn't to be discussed around here.

Jegan
02-15-2015, 02:37 PM
That vendor isn't to be discussed around here.

who? Saberforge?

my apologies, I was not aware.

Forgetful Jedi Knight
02-15-2015, 02:39 PM
who? Saberforge?

my apologies, I was not aware.

Yes, that "vendor". Now you know.