enigma1861
01-27-2015, 09:43 AM
10803
Ok. So, while awaiting the arrival of my NB 2.0 and other parts, I'm drawing out how I'm going to wire everything up for a purple blade and flash on clash with a cree XPE-2 red-green-royal blue LED.
I'm trying to utilize the MWS harness in the same manner that Madcow demonstrated in his "build a basic saber with sound" videos. As noted in Madcow's youtube post, the current harness is different from the one he used in the video.
Here is the harness I will be using:
http://www.thecustomsabershop.com/NB-V2-MWS-Header-and-Wiring-Harness-P961.aspx
The only thing I'm not sure about is whether or not I can connect the black wire from the harness to the (-) terminal of the battery holder and connect the adjacent yellow wire to the (battery -) terminal on the NB. The ground wire from the switch and the (-) wire from the power extender would then be connected to the corresponding pin that would connect to the harness where the black and yellow wires come together.
Sorry for the long-winded post, but I'm trying to be as specific as possible.
Also, if this post would have been better suited in the "LED hilts and wiring discussion", then I apologize.
Thanks.
Ok. So, while awaiting the arrival of my NB 2.0 and other parts, I'm drawing out how I'm going to wire everything up for a purple blade and flash on clash with a cree XPE-2 red-green-royal blue LED.
I'm trying to utilize the MWS harness in the same manner that Madcow demonstrated in his "build a basic saber with sound" videos. As noted in Madcow's youtube post, the current harness is different from the one he used in the video.
Here is the harness I will be using:
http://www.thecustomsabershop.com/NB-V2-MWS-Header-and-Wiring-Harness-P961.aspx
The only thing I'm not sure about is whether or not I can connect the black wire from the harness to the (-) terminal of the battery holder and connect the adjacent yellow wire to the (battery -) terminal on the NB. The ground wire from the switch and the (-) wire from the power extender would then be connected to the corresponding pin that would connect to the harness where the black and yellow wires come together.
Sorry for the long-winded post, but I'm trying to be as specific as possible.
Also, if this post would have been better suited in the "LED hilts and wiring discussion", then I apologize.
Thanks.