Noyl Wendor
12-31-2014, 05:28 PM
So I'm considering building a MHS v2 hilt. Here's the parts I'm considering
BH Style 3
choke Style 1
5" double female extension
male v2 to female v1 adapter
.75 MHSv1 extension (enough room for a standard 28mm speaker holder)
MPS Pommel style 2
I'm going with a Nano 2 (of course when available), tri-rebel BBW (white FOC) hopefully in hilt recharge, and if at all possible a 16mm momentary switch with light up ring (blue).
What I'm wondering is, if anyone has had any experience with a switch and RC port installed on one of these? Maybe a little elaboration, could be helpful.
Granted I'm not rushing off to do this all right now. I'm going with a slow project to start off the new year. There's still a few parts out of the store that would be needed to do the build.
Any thoughts? ;)
BH Style 3
choke Style 1
5" double female extension
male v2 to female v1 adapter
.75 MHSv1 extension (enough room for a standard 28mm speaker holder)
MPS Pommel style 2
I'm going with a Nano 2 (of course when available), tri-rebel BBW (white FOC) hopefully in hilt recharge, and if at all possible a 16mm momentary switch with light up ring (blue).
What I'm wondering is, if anyone has had any experience with a switch and RC port installed on one of these? Maybe a little elaboration, could be helpful.
Granted I'm not rushing off to do this all right now. I'm going with a slow project to start off the new year. There's still a few parts out of the store that would be needed to do the build.
Any thoughts? ;)