View Full Version : Can the MHSv1 copper heatsink fit into the holder of an MHSv2 Heat Sink
WookieeGunner
12-31-2014, 09:38 AM
Looking at building an MWS based setup but my blade holder is an V2. Can I buy the MWS LED and then swap the outer aluminum shell with a V2 version?
Silver Serpent
12-31-2014, 11:01 AM
I'm pretty sure the answer is no. The heatsink part looks smaller in the pictures.
I would contact Strydur about having a v2 MWS LED module built instead.
WookieeGunner
12-31-2014, 12:00 PM
Yeah, that is what I was figuring. I expect the aluminum shroud is smaller on the V2 but I was hoping the copper piece was simply the MHS V1 flat.
Strydur
12-31-2014, 05:35 PM
It is smaller.. I will put MHS V2 MWS modules on the site soon.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.