NBv2 Mono switch, Amber Rebel, charge port with trustfire 3.7V Wiring CHECK

[MrCafe]

I have wired saber up befroe but it has always been with a buckpuck or a "kit" so this it the first one that I had to do all the work myself. Sooooo before I fry a board or LEDs I figure I would ask the pros here on the forum if it all looks good

Hardware
- 16mm Anti Vandal Momentary Gold Plated Switch
- Nano Biscotte Sound Module V2
- 2W speaker
- Amber 171 lm @ 700 mA 3.2V to run at 700 mA Rebel
- Single Trustfire 18650 3000 mAh 3.7V
- 1 Ohm 1/2 WATT resistor
- MWS Recharge Port

https://hostr.co/file/NXYD41y1AyoH/wirdie.jpg

Thank you for looking guys. I am using MWS so I can change out LED or later make a better internal mount for the battery/sound card system.

[Silver Serpent]

Your diagram appears correct.

[MrCafe]

awesome ty Silver Serpent, anyone know if I got the calculations for the resistor correct?

[Silver Serpent]

Yes, that resistor value is fine.

[MrCafe]

Again thank you SS! Now to wire this puppy up. Maybe a while before I post finished product as my wife and I are in the middle of moving into our first house.

[snilam]

Congrats on the house!

[MrCafe]

Thank you man. I will have space for a REAL workshop... now if only I can get a raise at work to fund my hobby...... Hrm.