Blade holder dimensions

[TheSilverDark]

So I think instead of using sink tubes I'm going to CAD then CNC my saber since it's cheaper and I have the ability, with exception of the CNC but I might be able to get Tim to help me with that. But I was wondering what the inner dimensions of the blade holder are cause I'm pretty sure if that gets screwed up I won't have a real saber anymore...

[Silver Serpent]

Well, the section for holding the blade is simple enough to figure out. It's about 1.5" - 2" deep, and 1" in diameter. Maybe a hair or two bigger in diameter, to allow the blades to slide in and out.

The section for holding heat sinks, now that I couldn't tell you for sure. You'd have to do those measurements yourself, or build a custom heatsink.