sks1138
05-22-2014, 06:37 PM
Hello all,
After some many years on here I've finally gotten around to building my first MHS saber. I've built a sinktube and PVC saber with hasbro econo boards. Now I'm ready to wire up my NB V2. I've read and researched and done my homework. After some more reading I had to re-draw my diagram and move some wires. I'm gonna use a Rb/G/G tri rebel for whatever Cyan comes out of it with green FoC. I only have some resistor Questions as well.
Is it better to use resistors(I have 1ohm 2w resistors for the main LEDs and a .5ohm 1/2w for the FoC) or use the drive and fdrive parameters on the board with the Rb and G leds?
Thanks everyone in advance for any help.
9979
After some many years on here I've finally gotten around to building my first MHS saber. I've built a sinktube and PVC saber with hasbro econo boards. Now I'm ready to wire up my NB V2. I've read and researched and done my homework. After some more reading I had to re-draw my diagram and move some wires. I'm gonna use a Rb/G/G tri rebel for whatever Cyan comes out of it with green FoC. I only have some resistor Questions as well.
Is it better to use resistors(I have 1ohm 2w resistors for the main LEDs and a .5ohm 1/2w for the FoC) or use the drive and fdrive parameters on the board with the Rb and G leds?
Thanks everyone in advance for any help.
9979