Just checking if I have evything I will need

[Darth Akuin]

First timer here and would just like to see if i got everything right before I get started ordering. Thank you all in advance for any and all help. I have all tools already.
9978


Hilt-
MHS Hilt style 4 (guarded switch)
MHS Double male connector style 2
MHS 1.2 Double female connector
MPS Pommel style 3 v1
MHSV1 Blade holder style 10 (heat sink v3 tri-rebels)
MPS insert style 6
MPS Clip

Blade-
1" thick trans white polyc 38" long
bullet tip for 1"

Electronics-
Luxeon Rebel star (red-orange)
Rebel star lens 8.7 and lens holder
2AA battery holder (18650)
MWS guarded style latching switch
buckpuck 700ma 4 wire

Other-
4 black O rings
Nylon screws
8-32 thumbscrew

[RavenXp]

I don't see anything glaring missing... Are you planning on drilling and tapping the blade holder yourself? Also, resistor for the LED.

[Darth Akuin]

I thought that with the buckpuck a LED resistor wasn't needed because it would do that for me, and yes I have drills and taps already so I thought I could do that myself.

[Silver Serpent]

You are correct. The 700mA Buckpuck will take the place of the resistor.

One thing: You have listed "2AA battery holder (18650)." The AA battery size is 14500. 18650s will not fit in the AA holder.

Nylon screws are no longer needed to hold LEDs in place on the heatsink. Get the thermal tape pad instead.

Everything else looks fine to me.

[Forgetful Jedi Knight]

First off, Welcome to the Forums!

You are correct, that is what the BuckPuck is for. Also, the AA battery holder (and AA batteries) are 14500's NOT 18650s. Unless you have wire handy already, you probably should pick up some more. Good Luck.

[Darth Akuin]

The battery sizing was just my error as I replaced my e-cig batteries, thank you all for your help, good to know my research has paid off and I wasn't missing anything crazy important

[Darth Akuin]

Also quick question, does anyone have any picture of the red orange on a blade, I've been looking and cant find any thing with the red orange

[Cire Yeldarb]

My Phoenix Saber has a Red-Orange Blade.

It is the last one I posted on this Thread: http://forums.thecustomsabershop.com/showthread.php?15896-My-Saber-Collection (Right under the Purple LightWhip)