PDA

View Full Version : I need a diagram for a short anti vandal with recharge port. Help please



rifleman5000
03-30-2013, 08:51 AM
855685548555
I am trying to use a short anti vandal and am kind of stuck. The long wired fine I just don't get the short.
Thanks

Ari-Jaq Xulden
03-30-2013, 08:54 AM
The third picture in the store shows it. + & - led are marked, other two are switch leads, doesn't matter which. The long one is the harder one to get.

rifleman5000
03-30-2013, 04:51 PM
I got it to turn off and on. Can't get the switch to light though

hedgehog1
03-30-2013, 05:07 PM
Can you give us a photo or two of your wiring? Perhaps then we can see what is up.

rifleman5000
03-30-2013, 08:48 PM
pics added

Ari-Jaq Xulden
03-31-2013, 05:19 AM
That is a latching switch. The Jst's will hook up to the other two for your light. My mistake earlier, I thought you were using the momentary switch. Depending on how your hooking it up you might need a resistor.

rifleman5000
03-31-2013, 06:07 AM
So battery jst to small pins, then the tabs out to the led? Resistor before the switch on the negative.

Ari-Jaq Xulden
03-31-2013, 09:00 PM
Now that I see the MWS buck puck I see some other issues. This happens all to often, You should look at the back of the board, and the description of what they mean here (http://www.thecustomsabershop.com/MWS-BuckPuck--P748.aspx). What you should have asked for was was a wiring diagram for the mws buck, it is not voltage - & + in as you have it wired. You also have the switch in the wrong place. The two pins for your jst to your switch led are marked A-,A+ on the rear of the card, along with where your switch, battery, etc go. The resistor goes to the two marked ARES. it completes the circuit , so no resistor, no light.

Check out this (http://forums.thecustomsabershop.com/showthread.php?15447-What-s-wrong-in-this-Pic&highlight=buck+puck) post Tim explains it better than I do.