NB Wiring

[jin starkiller]

This will be my first attempt at wiring up a NB. Question I have is from the manual it says I need an resistor for the main led.
i have a P4 Led and it has a forward voltage of 3.25 according to the store and using a 3.7 volt battery

Question 1. so I would need a 2w 1ohm resistor ...correct
Question 2. I am using a accent led and that I can just tie in with the main led

[Forgetful Jedi Knight]

This will be my first attempt at wiring up a NB. Question I have is from the manual it says I need an resistor for the main led.
i have a P4 Led and it has a forward voltage of 3.25 according to the store and using a 3.7 volt battery

Question 1. so I would need a 2w 1ohm resistor ...correct
Question 2. I am using a accent led and that I can just tie in with the main led

To answer your questions:

1. Yes.
2. You can either tie it into the main LED (it might need a resistor too, depending on what your using), OR you can use the 3.3v pad which would be ideal for one accent LED

[Silver Serpent]

If you connect the accent LED to the main LED, you want to wire it in parallel, not in series. You will need a resistor for it as well.