PDA

View Full Version : Soldering Resistors onto the Petit Crouton



Darth Noir
08-10-2012, 09:03 AM
So after doing reading on the petit crouton I decided to use it on my next build. I read the manual "cover to cover" a few times and it's a wonderful source of information. There's one part though that is a bit vague. It has a detailed section on resistors but not how to wire them onto the board. I read the section on resistor pads but I myself am not familiar on how to solder something like that and my Internet/forum searches only yield threads on calculating resistors. If someone could show a picture or explain how the resistors are wired onto the board I'd be very happy.

Jay-gon Jinn
08-10-2012, 09:15 AM
The resistors on the PC 2.0 are very small and can be difficult to solder. They look like this when soldered to the board:
http://i119.photobucket.com/albums/o141/Jay-gon_Jinn/Chrome%20Saber%2039/100_1969.jpg
The process is about the same as soldering anything else, pre-tin the pads, then add the resistor. I usually solder one side first, then the other. You'll want some really small tweezers to hold onto the resistor with.

Darth Noir
08-10-2012, 11:56 AM
Wow that is tiny. Ok that clears up my confusion. So both pins of the resistors are soldered onto the pad, then the led is wired onto the board like all others.

Silver Serpent
08-10-2012, 12:18 PM
The resistor pads on the PC 2.0 board are already bridged. If you're not comfortable with surface mount soldering, you can just use a regular resistor inline with the accent LEDs. It takes up a little more space, but it's far easier when you're starting out.

JRD1
08-10-2012, 01:35 PM
The resistor pads on the PC 2.0 board are already bridged. If you're not comfortable with surface mount soldering, you can just use a regular resistor inline with the accent LEDs. It takes up a little more space, but it's far easier when you're starting out.

I do this and I am good with a soldering gun, just easier and less time consuming for the same result.