clash sensor on vader

[darkjedi_06]

I am having some trouble removing my clash sensor on my vader, would it be possible to use a hasbro clash sensor and connect it to the gray wire on the vader saber?

"The circle is now complete, when i left i was but the learner, now I am the master."

[Do-Clo]

I am not sure on that one, since the MR board is more costly than the Hasbro board I would go with caution and use the MR clash sensor. You can drill a small hole on either side of the of the pin that holds the led strip into the blade and use a pair of needle nose pliers to pull the pin out.

<center>http://i48.photobucket.com/albums/f217/Do-Clo/DoCloSig.jpg</center>
<center><font color="red"><font size="4"><font face="Comic Sans MS">Darth Technous Sith Lord</font id="Comic Sans MS"></font id="size4"></font id="red"></center>
<center><font color="red"><font size="4"><font face="Comic Sans MS">Give yourself to the Dark Side</font id="Comic Sans MS"></font id="size4"></font id="red"></center>

[Lord Maul]

or you can use a nail punch and a finnishing hammer to push the pin in, that is what i did. just make sure it is all the way through before you pull the led strip out. mine wasn't and i cracked the blade so i had to cut it down 3 inches

<center>http://film.onet.pl/_i/news/duze/d/darth_maul_1.jpg

http://www.clicksmilies.com/s0105/starwars/star-wars-smiley-026.gif At last we will reveal ourselves to the jedi, at last we will have revenge. http://www.clicksmilies.com/s0105/starwars/star-wars-smiley-026.gif
</center>