Hilt Design

[Evilpancreas]

693769386936

I pulled apart a broken $10 crap lightsaber. Though its made of plastic, I really liked the design on it. I want to see if any of you can make schematics for the design in MHS.

[Silver Serpent]

http://forums.thecustomsabershop.com/mhsbuilder/mhsbuilder.php

Fiddle with this and you should be able to come up with something. You'll need to do an overlay for the ribbed bits.

[Evilpancreas]

Since I've never seen an explanation on it, how do you attatch overlays?

[Silver Serpent]

Depends on the overlay and the design of the saber. Small overlays can be attached with epoxy. Larger ones are usually held in place with screws, switches, etc.

[vadeblade]

Playing with MHS Builder (http://forums.thecustomsabershop.com/mhsbuilder/mhsbuilder.php)...

69566958

You will need to buy MHS Sleeve material (http://www.thecustomsabershop.com/MHS-Sleeve-material-P468.aspx)or sink tube (http://www.thecustomsabershop.com/1-12-x-12-Chrome-sink-tube-P84.aspx)to make those three "ring" like overlays.

[Evilpancreas]

Very nicely done vadeblade. I wanted to see how people would attempt to make it in the MHS builder. This may possibly be my next saber build.