PDA

View Full Version : hasbro wiring question


jezzail
09-02-2006, 03:27 PM
okay. will the setup that is about 3 from the top here http://www.thecustomsabershop.com/sabers/forum/topic.asp?TOPIC_ID=389 eliminate the flashing problem? I used search and didn't find a definite answer, so please help me.
xwingband
09-02-2006, 04:05 PM
If you use the one that has two buttons, yes. The corbin one will too. The rest that use the output of the Hasbro to run the LED will not get rid of the flash on clash.

To eliminate the second switch you could go with the use of a relay. Use the output of the Hasbro to trigger the resistor. Just like the EL setup.

<center>Read the FAQ (http://www.thecustomsabershop.com/sabers/forum/topic.asp?TOPIC_ID=552) or x-wing won't be happy. :(
Before posting did you check the Thread Index (http://www.thecustomsabershop.com/sabers/forum/topic.asp?TOPIC_ID=577)?.

http://img508.imageshack.us/img508/6703/xwing8az.gif</center>
jezzail
09-02-2006, 04:08 PM
could you give me a diagram of the relay setup please?
xwingband
09-02-2006, 04:26 PM
Oh, nevermind... I was spacing. lol, I was looking at the topic for it and I messed it up there too. You have to have a non-flashing board for that to work.

<center>Read the FAQ (http://www.thecustomsabershop.com/sabers/forum/topic.asp?TOPIC_ID=552) or x-wing won't be happy. :(
Before posting did you check the Thread Index (http://www.thecustomsabershop.com/sabers/forum/topic.asp?TOPIC_ID=577)?.

http://img508.imageshack.us/img508/6703/xwing8az.gif</center>
jezzail
09-02-2006, 04:33 PM
oohhhh! well thanx for such a quick reply, and for clearing up that question.