Dimsim
01-11-2012, 01:31 PM
Greetings to all Masters and Lords,
I'm a new Belgian guy here, finally starting on a childhood dream, owning a real lightsaber with light and sound.
Before placing the order I just want to make sure my parts are correct and the build will work.
Here I ask you to bestow your knowledge unto me and aid me in my smithing.
The parts:
x3 Clash snensor (for if I ruin one)
x3 Swing sensor (for if I ruin one)
x1 8-32 x 1/2" thumb screw
x2 2 wire quick connector
x1 1/8" adhesive lined heatshrink tubing
x1 Seoul P4 LED & MHS Heatsink module (red) (needed a 2.7 OHM 2 Watt resistor which I did not find on the site, is more watt good too?)
x1 Hilt style 3 with standard style switch hole
x1 MHS Choke style 1
x1 Blade holder style 6 "new style"
x1 MPS Pommel style 8
x1 push on/off switch (latching)
x1 4AAA Battery holder
x1 Blade film (quad wrap 1" thick walled") (I read quad wrap is better for even brightness?)
x1 LED TCSS Style Battle blade 1" OD 40 inches
I found a Darth Vader soundboard (http://www.benl.ebay.be/itm/350518671584?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649) on Ebay, will it still fit the hilt after the wiring?
6298
I'm a new Belgian guy here, finally starting on a childhood dream, owning a real lightsaber with light and sound.
Before placing the order I just want to make sure my parts are correct and the build will work.
Here I ask you to bestow your knowledge unto me and aid me in my smithing.
The parts:
x3 Clash snensor (for if I ruin one)
x3 Swing sensor (for if I ruin one)
x1 8-32 x 1/2" thumb screw
x2 2 wire quick connector
x1 1/8" adhesive lined heatshrink tubing
x1 Seoul P4 LED & MHS Heatsink module (red) (needed a 2.7 OHM 2 Watt resistor which I did not find on the site, is more watt good too?)
x1 Hilt style 3 with standard style switch hole
x1 MHS Choke style 1
x1 Blade holder style 6 "new style"
x1 MPS Pommel style 8
x1 push on/off switch (latching)
x1 4AAA Battery holder
x1 Blade film (quad wrap 1" thick walled") (I read quad wrap is better for even brightness?)
x1 LED TCSS Style Battle blade 1" OD 40 inches
I found a Darth Vader soundboard (http://www.benl.ebay.be/itm/350518671584?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649) on Ebay, will it still fit the hilt after the wiring?
6298