hasbro Quick release Darth Vader internals removal question

[Bloodshovel]

First off let me apologize if this has already been posted and I just skimmed past it.

For the most part this has disassembled exactly as the other Vaders listed above. However I'm here....
http://i1090.photobucket.com/albums/i362/droidliam/2012-01-05093027.jpg
http://i1090.photobucket.com/albums/i362/droidliam/2012-01-05093049.jpg

this is located underneath the thumb switch, and I'm guessing that it's 1(or2) pieces of all-thread that go all the way through the saber form side to side to hold the internals in. Before I take a dremel tool cutting wheel and groove it so I can screw it back out, I was wondering if anyone can confirm my theories.

Are there threaded holes present there on other models? All the pictures I've seen still have the button sleeve still on.

Thanks a ton guys.

[Jay-gon Jinn]

Chances are that is a pin, and not a screw. You'll have to use a hammer and punch to tap it out.

[Bloodshovel]

It was in fact a pin, thanks Jay. Backed out really easily, pulled it out the rest of the way with some pliers. Used a pen to push the internals out through the top.

I think I'm going to see if I can re-sheath the internals in a combination of PVC and HIPS as my first project before I move into Lathes and whatnot :D