View Full Version : Ripped off solder pad on Ultrasound 2.0
scout malikim
10-23-2011, 08:30 AM
I accidently ripped off the battery+ solder pad on my Ultrasound 2.0. How do I go about repairing this? It was cleaning ripped off. Can I just glue it back on?
post a pic to see how bad.. usually you can scrape bit back on the trace (solder mask) to reveal some more 'copper'... and try to solder to that.
scout malikim
10-24-2011, 04:12 PM
attached is a picture. I don't see where I could solder to?
6050
if you follow thr pad up..to where the trace is....
you can scrape a bit of the mask off.. LIGHTLY.. to reveal some more copper underneath..
I'll have to pull out a US board to get a better look..but should be right above it
scout malikim
10-26-2011, 12:01 PM
Was able to get things working again by connecting to a different part of the card. I attached a pic showing 2 locations that worked as substitutes for the battery+ pad. Thanks for the help.
6056
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.