measurements for the switches

[Ripper]

I was wondering if anyone knew the measurements to the hole size for the DPDT Latching switches. I looked all over the store and I can’t find it. Anyone know. I wanted to get a drill bit for it. Or the size of the switches would help.

[Elodin]

As far as I can tell 5/8" is the drill bit you'll need. The info is drawn from here (http://forums.thecustomsabershop.com/showthread.php?12358-Jay-gon-Jinn-s-MHS-Mara-Jade%28ish%29-build-%28MHS-Petit-Crouton-7.4v-Li-Ion-AV-switch%29&highlight=mara). I'd recommend double checking though.

[jin starkiller]

this shouldanswer a lot of questions on freq used drillbit and measuements for this hobby

http://forums.thecustomsabershop.com/showthread.php?11154-Commonly-used-Drill-bits-taps-and-measurements