Jedi Mynock
06-20-2011, 12:34 PM
so i am rebuilding my MHS and giving it a massive update.
would i need a heatsink for a P4 overdriven at 1100ma?
and will it fit into choke 1 short under bladeholder 1?
would the OD of the heatsink need to be reduced (lathe) to fit inside the choke?
i might also be switching to the ribbed extension choke combo, and might have the same problem?
i tried to work it out in the MHS builder but without measurements of choke ID, it really makes my noggin itch lol
thanks!
would i need a heatsink for a P4 overdriven at 1100ma?
and will it fit into choke 1 short under bladeholder 1?
would the OD of the heatsink need to be reduced (lathe) to fit inside the choke?
i might also be switching to the ribbed extension choke combo, and might have the same problem?
i tried to work it out in the MHS builder but without measurements of choke ID, it really makes my noggin itch lol
thanks!