View Full Version : Questions about the chassis disks and threaded rods
Waisulee
04-19-2011, 06:47 AM
First of I gotta say these chassis disks look great! Was so excited when I first saw them. Great job :) But wanted to make sure of a couple of things. Am I to assume that the chassis disk style 2 fits well in a graflex, the treaded rods then fits in the holes, then the 3/16" OD tubes fit around the threaded rods as chassis spacers. I'm sure they fit together as I described, just want to be certain before I buy. Are there anything else I should keep in mind re these items and their assembly? Thanks :)
Skottsaber
04-19-2011, 09:15 AM
Graflex and MHS ID's are not the same.
Rafalema
04-19-2011, 11:48 AM
Yea, the disk will fit in the graflex.
But it'll rattle without mods :lol:
Azmaria Dei
04-19-2011, 12:28 PM
a bit of PVC heatshrink around it will fix that though.
IG-88
04-19-2011, 03:52 PM
a bit of PVC heatshrink around it will fix that though.
If you get the chassis disk style 1 it should fit inside the graflex...it's OD is 1.31" so it will still have some wiggle inside a graflex, but not as much wiggle as the style 2. ;)
FenderBender
04-19-2011, 04:25 PM
If the chassis is secured to the bladeholder (like most Gflex builds) then there won't be any (shouldn't be any) rattling. Just sayin'...
cardcollector
04-20-2011, 08:56 AM
If the chassis is secured to the bladeholder (like most Gflex builds) then there won't be any (shouldn't be any) rattling. Just sayin'...
A good point, fender makes.
Waisulee
04-21-2011, 05:08 AM
Thanks guys. You all kinda' confirmed some things I was thinking. Cool :D
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.