undescriptive
01-09-2011, 05:21 PM
Hi everyone,
I am seriously looking at running a String blade.
I currently have a 1A buckpuck, but running an LED every 0.5inches means at best I can get a 16.5" blade!
I am looking at using http://www.thecustomsabershop.com/Constant-current-LED-driver-P609.aspx running at 1500ma.
would this driver work (along with the shimmer effect) OK?
I'm not worried about using any scrolling (I only have a 2010 el-cheapo vader soundboard), so I'm assuming it will just act like a "single" LED.
Also, running this driver, would I connect the driver and the soundboard from the same switch? would I need a double pole type or could I run it from a single?
Thanks in advance!
I am seriously looking at running a String blade.
I currently have a 1A buckpuck, but running an LED every 0.5inches means at best I can get a 16.5" blade!
I am looking at using http://www.thecustomsabershop.com/Constant-current-LED-driver-P609.aspx running at 1500ma.
would this driver work (along with the shimmer effect) OK?
I'm not worried about using any scrolling (I only have a 2010 el-cheapo vader soundboard), so I'm assuming it will just act like a "single" LED.
Also, running this driver, would I connect the driver and the soundboard from the same switch? would I need a double pole type or could I run it from a single?
Thanks in advance!