PDA

View Full Version : Hilt/parts dimentions?


LES
12-29-2010, 07:22 AM
Hope it is allright to post this here. If not, feel free to move it to the rigth spot!

I have been unable fo find conclusive answers to these questions:

The OD of the MHS is 1,45" if I`m not mistaking, but the ID is a difrent storry, some say 1,4" some say 1,3" and I`ve even seen 1,25". So what is true?????

And I would realy like if someone could give me the OD on the Anakin conversion kit, along with the length of the part of it that is supposed to be inside the hilt!!

Sorry for the first question, just found it!!!
Skottsaber
12-29-2010, 07:33 AM
MHS is 1.25" ID
LES
12-29-2010, 07:37 AM
Thank You!!!!
Jay-gon Jinn
12-29-2010, 08:29 AM
That depends on the part....some of them, like the ribbed extensions and combos with chokes are much smaller than 1.25".
LES
12-29-2010, 08:43 AM
Was thinking of the standard one, doing my own custom work annyway!
Azmaria Dei
12-29-2010, 08:43 AM
pommels and the double male slotted are the same ID and are ~1.14".
LES
12-29-2010, 09:04 AM
pommels and the double male slotted are the same ID and are ~1.14".

Thank You!!! That was actually realy usefull information since it has greate impact on a idè I`m working on!!!!
Azmaria Dei
12-29-2010, 09:12 AM
Thank You!!! That was actually realy usefull information since it has greate impact on a idè I`m working on!!!!

ah then so you don't have to do any conversions - my caliper measures them at 29mm exactly. just in case you have to use everything in metric. ^_^
LES
12-29-2010, 10:34 AM
ah then so you don't have to do any conversions - my caliper measures them at 29mm exactly. just in case you have to use everything in metric. ^_^

Inches is ok, I know the formula!! As for the conversons, I need to do some converting, but probably less!