My second saber

[AEwizard]

Soooo..... here is the parts list for my second saber. It is run by a economy Hasbro board.


7" Fluted with guarded style switch hole

Screw on LED blade holder style 10

MHS choke style 1

MPS Pommel style 4

SPST Momentary Guarded switch with silver button

Seoul P4 (Red)

Luxeon III/P4 Lens Holder

Luxeon Collimator Lens 5 deg viewing angle

2.1mm Power Jack

Kill plug style 1

PCB for 7.2V Li-ion battery packs

Li-Ion 14500 Rechargeable AA size 3.7V 900mAh x2

2AA Battery holder

MPS Clip

MPS Insert style 6

PNP type power transistor

5v regulator

2.2 ohm resistor

is that it? please respond.

[jjshumpert]

looks good, which econ board will you be using in this hilt?

[AEwizard]

I will be using the obi-wan board. Is there a difference between the vader and the obi-wan?

[jjshumpert]

ive heard of the 2010 boards having different fonts, but i havent had much experience with this as i only use the vader boards

[Skottsaber]

They all have the same sounds ;)

[MooseStuff]

The obi is a much smaller board while the vader was a tight fit for me. i used both but was working on the obi and was distracted and messed it up with my iron so i had to replace it with my vader board.

[Ronan]

Your sig is too small ;)

[jin starkiller]

looks good...maybe some powdrecoating for the parts

[AEwizard]

hmmmmm. i might add some later. i dint know because im sort of short on money right know.