View Full Version : My second saber

10-17-2010, 08:04 AM
Soooo..... here is the parts list for my second saber. It is run by a economy Hasbro board.

7" Fluted with guarded style switch hole

Screw on LED blade holder style 10

MHS choke style 1

MPS Pommel style 4

SPST Momentary Guarded switch with silver button

Seoul P4 (Red)

Luxeon III/P4 Lens Holder

Luxeon Collimator Lens 5 deg viewing angle

2.1mm Power Jack

Kill plug style 1

PCB for 7.2V Li-ion battery packs

Li-Ion 14500 Rechargeable AA size 3.7V 900mAh x2

2AA Battery holder

MPS Clip

MPS Insert style 6

PNP type power transistor

5v regulator

2.2 ohm resistor

is that it? please respond.

10-17-2010, 08:21 AM
looks good, which econ board will you be using in this hilt?

10-17-2010, 08:23 AM
I will be using the obi-wan board. Is there a difference between the vader and the obi-wan?

10-17-2010, 08:28 AM
ive heard of the 2010 boards having different fonts, but i havent had much experience with this as i only use the vader boards

10-17-2010, 08:31 AM
They all have the same sounds ;)

10-17-2010, 09:54 AM
The obi is a much smaller board while the vader was a tight fit for me. i used both but was working on the obi and was distracted and messed it up with my iron so i had to replace it with my vader board.

10-17-2010, 05:55 PM
Your sig is too small ;)

jin starkiller
10-17-2010, 06:14 PM
looks good...maybe some powdrecoating for the parts

10-18-2010, 12:04 PM
hmmmmm. i might add some later. i dint know because im sort of short on money right know.