Question about making a choke [PICS]

[Bilivdat]

Hello there !
I am making my saber but I have a little problem on a choke part like Madcow's lightsabers:

http://s2.noelshack.com/old/up/exemple-f180590a38.jpg

I wanted to make this one by myself on adding a "1.25 in. sink tube" between two "MHS to 1.25.in sink tube adapters" like this I pictured on the MHS SaberBuilder:

http://nsa18.casimages.com/img/2010/08/21/100821074826655798.jpg

I don't own any drill machine but I would make it pretty nice and resistant, obviously with tcss parts.

Thank you for helping and MTFBWY.

[Rafalema]

You got nice pics and everything, but the sinktube adapters are WAY too short in your render.

Secondly, I fail to see the question.

[Jedi-Loreen]

That won't work. The end of just one of those sink tube adapters is longer than the whole choke you want to make in your render.

http://www.thecustomsabershop.com/Assets/ProductImages/Picture_162.jpg

The MHS Builder only shows the part that sticks out of the sink tube, not the part that goes inside it.

And how would you even connect the 2 adapters and sink tube anyway, if you don't have a drill?

Is there a reason why you don't just want to buy this short choke?

http://www.thecustomsabershop.com/Assets/ProductImages/180_8083.jpg

[Bilivdat]

Well thank you ! I will buy the choke you propose :)