helpage

[TI-525]

i need help on how to put the button for the covertech clip on my hilt
i bought the machined and i also have the regular button that came with the clip
any help would be good

[Strydur]

bolt or rivet it on.

Tim
The Custom Saber Shop

[Jedi Ranger]

Hopefully you know that you'll need to drill a matching hole in your hilt in order to mount it.[;)]

http://www.members.shaw.ca/Dahak/

[vadeblade]

I purchased an aluminum covertec button from Tim. The shops says it is curved for a 1.5 inch pipe. I attached it to a 1.375 inch pipe and it looks just fine.

Here is how it looks:
http://www.geocities.com/projectstm/hilts/covertec_wheel.jpg

Forgive the poor picture quality, I used a camera phone. Anyway, the button (wheel? knob?) is attached using a 6-32 x 1/2 inch button-head cap screw. I drilled and tapped a 6-32 thread hole in the hilt. For added security the screw also goes into a small 6-32 nut inside the hilt. I think an 8-32 screw would work too, but I have an over abundance of 6-32 machine screws.

Question, is the piece I purchased anodized? how about the blade holders?

Lightsaber Warning Label: "CAUTION: Do NOT attempt to sharpen blade."

[Strydur]

Those buttons might have been..the other stuff I sell is not.

Tim
The Custom Saber Shop