PhoenixReborn
05-19-2010, 10:17 PM
What is the size of the drill bit I would need to drill a guarded switch hole?
Jay-gon Jinn
05-23-2010, 12:13 AM
That depends on whether or not you plan to use the retaining nut. If you do, 1/2" will work. If not, and this is what I do because it's a real PITA to get that nut tight enough to prevent the switch from rotating in the hole, use a 7/16" bit and force fit the switch into the hole.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.