Knighthammer
05-13-2010, 12:54 PM
I've got my hilt parts on the way currently and I'm looking at what I'm thinking for the electronics. Not sure if I should have listed this in the LED electronics section or not, but since this seemed the place for parts lists....
Phase 1: Relatively simple lighted blade:
DPDT Latching red illuminated switch (realize I will need some sort of resiter for this)
Luxeon III Star (Red)
Luxeon Collimator Lens 5 deg viewing angle
Luxeon III/V Lens Holder
BuckPuck 700mA 4-wire
4AA Battery holder
LED "TCSS style" Battle blade 1" OD
Star thermal tape pad
2 Wire quick connector
Phase 2: Adding Sound
I've got a complete sound / LED blade out of a older Vader FX saber, I think its a 07. I was thinking of taking the sound board from that and integrating it into the saber. Would it be worth it - or would it be better to use it in some other saber that I could take advantage of the LED chain style blade from it?
Thanks for the assistance.
Phase 1: Relatively simple lighted blade:
DPDT Latching red illuminated switch (realize I will need some sort of resiter for this)
Luxeon III Star (Red)
Luxeon Collimator Lens 5 deg viewing angle
Luxeon III/V Lens Holder
BuckPuck 700mA 4-wire
4AA Battery holder
LED "TCSS style" Battle blade 1" OD
Star thermal tape pad
2 Wire quick connector
Phase 2: Adding Sound
I've got a complete sound / LED blade out of a older Vader FX saber, I think its a 07. I was thinking of taking the sound board from that and integrating it into the saber. Would it be worth it - or would it be better to use it in some other saber that I could take advantage of the LED chain style blade from it?
Thanks for the assistance.