Darth Mikis
05-01-2010, 01:48 PM
Hello i was making a saber on TCSS and wanted input on if everything looks alright and if i should need or get anything else with it..all of the items are from the TCSS store, so here is the list:
Hilt style 2 with guarded style switch hole
MHS choke style 1 long
MPS Pommel style 3 v1
Screw on LED blade holder style 11
MPS Clip
MPS Insert style 1
LED "TCSS style" Battle blade 1" OD (36 inches)* ** Bullet Shaped
Build Your Own Seoul P4 Electronics Kit
* 4AA Battery holder
* Seoul P4 (Red)
* Collimator Lens 5° viewing angle
* 3.3ohm 5w resistor
* Push on/push off switch with red button
* Luxeon III/V Lens Holder
Powder Coating Powder Coating (Solar Flat Black, PM31)
Powder Coating Powder Coating (Solar Flat Black, B111)
Powder Coating Powder Coating (Solar Flat Black, C1L2)
Powder Coating Powder Coating (Solar Flat Black, SH23)
DPDT Latching red illuminated switch
Machine switch hole in MHS section (illuminated)
location: main body, Hilt style 2 with guarded style switch hole
***edited***
Drill & Tap Hole
Drill & Tap Hole (8-32)
location: blade holder to secure blade....
8-32 x 3/8" button head screw
Do i need anything else? or any other suggestions, such as quick disconnects, 5 or 10 degree collimator, i dont want sound as of now...
Hilt style 2 with guarded style switch hole
MHS choke style 1 long
MPS Pommel style 3 v1
Screw on LED blade holder style 11
MPS Clip
MPS Insert style 1
LED "TCSS style" Battle blade 1" OD (36 inches)* ** Bullet Shaped
Build Your Own Seoul P4 Electronics Kit
* 4AA Battery holder
* Seoul P4 (Red)
* Collimator Lens 5° viewing angle
* 3.3ohm 5w resistor
* Push on/push off switch with red button
* Luxeon III/V Lens Holder
Powder Coating Powder Coating (Solar Flat Black, PM31)
Powder Coating Powder Coating (Solar Flat Black, B111)
Powder Coating Powder Coating (Solar Flat Black, C1L2)
Powder Coating Powder Coating (Solar Flat Black, SH23)
DPDT Latching red illuminated switch
Machine switch hole in MHS section (illuminated)
location: main body, Hilt style 2 with guarded style switch hole
***edited***
Drill & Tap Hole
Drill & Tap Hole (8-32)
location: blade holder to secure blade....
8-32 x 3/8" button head screw
Do i need anything else? or any other suggestions, such as quick disconnects, 5 or 10 degree collimator, i dont want sound as of now...