Hrimhari
04-22-2010, 08:07 PM
I am looking for a parts list that would best make a Maris Brood like sabers.
Here is the list I have compiled over the last few minutes
4" Double Female Thread Connector
4" Fluted DFTC (Double Female Thread Connector)
MHS Ribbed Extension
Blade Holder Style 18
Double Male /w Slots
Double Ended Male TC
1.2" Double Female
Pommel Style 7
MPS Insert Style 6
And of course
Tonfa MHS Adapter
Tonfa Handle Style 1
Tonfa Pommel Style 1
According to the SaberBuilder the total length would be 17.26" which is not to bad for a guard shoto design.
Any ideas on this set up?
http://i6.photobucket.com/albums/y236/FoxFireGraphicsInc/SaberBuilderRender.jpg
or
http://i6.photobucket.com/albums/y236/FoxFireGraphicsInc/SaberRender.jpg
Note the black line is to show where the Tonfa handle would be put.
Here is the list I have compiled over the last few minutes
4" Double Female Thread Connector
4" Fluted DFTC (Double Female Thread Connector)
MHS Ribbed Extension
Blade Holder Style 18
Double Male /w Slots
Double Ended Male TC
1.2" Double Female
Pommel Style 7
MPS Insert Style 6
And of course
Tonfa MHS Adapter
Tonfa Handle Style 1
Tonfa Pommel Style 1
According to the SaberBuilder the total length would be 17.26" which is not to bad for a guard shoto design.
Any ideas on this set up?
http://i6.photobucket.com/albums/y236/FoxFireGraphicsInc/SaberBuilderRender.jpg
or
http://i6.photobucket.com/albums/y236/FoxFireGraphicsInc/SaberRender.jpg
Note the black line is to show where the Tonfa handle would be put.