MRFX Yoda mA output?

[Shadar Al'Niende]

As the title states, i cannot seem to find a definitive answer to this. I think the output is 350 mA. Any verification on this?

[cardcollector]

I remember reading that the MR's and FX's give out anywhere from 700ma-900ma depending on input voltage...

but don't quote me on that...;)

[Rhyen Skytracker]

I have been getting around 1200 mA with 4.8 Volt Nimh and 6 Volt regular batteries.

[cardcollector]

Woah! This is a yoda MR board???

That's sooooo sweet!:cool:

[Shadar Al'Niende]

excellent, now i just have to figure out how to modify the current for an led whos max rating is only 350...

*edit*

I have been told that the prolights from DX can take the 1200 ma that this will put out, can this be verified by someone who has used these? Specifically Fender?

[FenderBender]

;)

I drive them regularly with FX boards without problems. In fact *knocks on wood* I have yet to blow one.

[Rhyen Skytracker]

If you don't want to rist the 1200 mA then just use 2 or 3 of the negative LED wires on the MR board. They average around 200 mA a piece.

[JamoUp]

You think it's safe to drive a ledengin 10w rgba? That is 700mA I think. Maybe use a buckpuck or only a few neg wires?

[Eco]

You think it's safe to drive a ledengin 10w rgba? That is 700mA I think. Maybe use a buckpuck or only a few neg wires?

No. The forward Voltage for a LEDengine is too high, you will fry your board.

[JamoUp]

the data sheet says the red runs at 2.24v- 3.20v and blue runs at 3.20v-4.16 @700mA