Activity Stream

I recommend you put at least a minimal resistor on any LED you install.

Thank you for your help!

Thank you for that. That has been my only issue with the actual saber. I fear one day I'll go to open it just to recharge it and I'm going to snap...

i appreciate this!!

unfortunatly no, the switchcraft style connector is designed to cut power to the electronics when the charging port in inserted, this looks like it...

We have a lot of the documentation for the proffie on the discord server, but to get you started here is where I recommend you get your basic proffie...

Well, have fun with all of that. Good luck, you’re VERY likely to need it.

I could and i seriously think i should have lol but i want to try the proffie at least once.

Welcome back. The CFX is around, you could use that.

Welcome back

Thanks for the quick response back. I'm working on a custom build, so fitting two 21700's may not be the biggest challenge. I've read about buck...

I HIGHLY doubt you’re going to find a dual cell setup that can actually fit inside a saber. Besides, trying to feed that kind of Voltage to a single...

I've been digging into things for a few weeks where I realize that a single-color maxes at 3 amps and three colors at 5.3 amps. I'm using the...

yep, should be good to go.

I'm only running one blade, looking at the diagram I'll only be using data 1. I have a LED momentary switch for on/off which I have the resistor for...

Yes, that would work well with it. I would go with the thin-walled show blade, since you aren't going to use it for dueling. This one:...

Ok. So its more of an issue of light diffusion. Cool. I will probably look into a new blade then. Is the 36' TCSS baselit "standard clear" a good...

I recall re-using the original blade on a few conversions I did back in the day, and they never looked as good as the TCSS replacement blades. The...

Thank you, sir!